Changes

Jump to navigation Jump to search
add more learning objectives and measurable outcomes to workshop checklist.
#'''''Always preview the cuts before commanding the machine to cut them.''''' Check the design to be cut to verify its position, orientation, and check for accurate pathing. Note that the front of the machine is rendered as the left-hand side of the preview, i.e. the material will spool out from left to right in the preview, rather than from top to bottom.
== Cutting! ==
Once both of the set up procedures are completed, the last step is as follows:
# Cut your design!
Again, this can be accessed through the cut dialogue and pressing selecting the `Output` option from the window '''''(only after previewing your cut)''''' or selecting the Cut object icon or pressing enter on the keyboard from within the preview menu.
By the end of this Workshop, you should:
* Understand understand how vectors work in relation the need for vectorsthe CAM software.* Know know how to properly size your material.*understand the process of going from CAD to CAM to physical prototype.*
#
By the end of this Workshop, you should be able to:
* How to load stock into the machine.*load your design into the CAM software.* Be able modify your design so that the CAM understands it.*weed your design.*use transfer paper to move an adhesive-backed vinyl design to the target surface.*use the heat press to weedmove a heat-transfer vinyl design to a piece of fabric. *
#

Navigation menu