Difference between revisions of "Type A Series 1 Pro 3D printer Maintenance"
Jump to navigation
Jump to search
(add header warning) (Tag: Visual edit) |
(Added all the photos) (Tag: Visual edit) |
||
Line 4: | Line 4: | ||
===Daily Cleaning=== | ===Daily Cleaning=== | ||
===Monthly Cleaning=== | ===Monthly Cleaning=== | ||
+ | |||
+ | # Dust the Machine | ||
+ | |||
==Maintenance== | ==Maintenance== | ||
===Daily Maintenance=== | ===Daily Maintenance=== | ||
− | === | + | |
+ | # Print out a calibration cube | ||
+ | # Adjust Z-Axis if required | ||
+ | |||
+ | [[File:Remove Holder.jpg|thumb]] | ||
+ | [[File:Remove HeatBlock.jpg|thumb]] | ||
+ | [[File:Hotend.jpg|thumb]] | ||
+ | [[File:E Setscreew.jpg|thumb]] | ||
+ | [[File:Do Not Remove.jpg|thumb]] | ||
+ | [[File:Check Teeth.jpg|thumb]] | ||
+ | [[File:Clean Setscrew.jpg|thumb]] | ||
+ | [[File:Remove backfan.jpg|thumb]] | ||
+ | [[File:Dirty Hotend.jpg|thumb]] | ||
+ | [[File:Clean hotend.jpg|thumb]] | ||
+ | [[File:Add new heatcompund.jpg|thumb]] | ||
+ | [[File:Correct Amount.jpg|thumb]] | ||
+ | [[File:Correct Seating of hot end.jpg|thumb]] | ||
+ | [[File:Too much compund.jpg|thumb]] | ||
+ | [[File:Alignment test.jpg|thumb]] | ||
+ | [[File:Fully Reassembled.jpg|thumb]] | ||
+ | |||
+ | ===Changing the Hotend=== | ||
+ | |||
+ | * '''Remove''' all filament | ||
+ | * '''Turn off''', '''unplug''', and let '''cool''' before starting work | ||
+ | ** ''Not doing so may cause burns and burning out the electrical systems'' | ||
+ | |||
+ | [[File:Remove Fan Holder.jpg|center|500x500px|Start by removing the two 3mx18 bolts holding together the fan guard, fan, and holder.]] | ||
+ | [[File:Remove Guide.jpg|thumb]] |
Revision as of 17:47, 8 April 2019
Note: this page is provided as a reference for the CaTS only. If you are not a CaTS, do not attempt anything on this page.
Contents
Cleaning
Daily Cleaning
Monthly Cleaning
- Dust the Machine
Maintenance
Daily Maintenance
- Print out a calibration cube
- Adjust Z-Axis if required
Changing the Hotend
- Remove all filament
- Turn off, unplug, and let cool before starting work
- Not doing so may cause burns and burning out the electrical systems