137
edits
Changes
Jump to navigation
Jump to search
→Typical Workflow
===Clean work area===
If a significant amount of material fell through the honey comb structure of the cutting table then it should be cleaned out. The front of the laser cutting can be opened and the table will slide out. There is an opening in the rear of the table that can be used to clean the inside.
== Checklist ==
# Understand the importance of turning on the filtration system and staying with the red lines while cutting
# Understand the difference between raster (pure black), etch (pure blue), and cut (pure red)
# make sure the object is being cut at .025 mm
# identify the material you want to use and select it in the setting
# identify the width of the material you are cutting and make sure it is matched in the settings
# understand how to import you cut into uls
# understand how to move your object using
<br />
