166
edits
Changes
Jump to navigation
Jump to search
m
change cooling jig subtitle to uppercase
===Set up the orientation of the design in the CAM software===
Now that you've got your design in UCP, double check again that your design looks accurate both structurally and in size. If you left lift the top of the machine open, you'll notice a red laser underneath the conical head of the cutter. Don't worry - that's just a standard laser pointer! It's there as a guide for you, which you'll now utilize.
[[File:Moving image to laser tool.png|thumb|"To Pointer" button. This tool allows you to move the corner of your design highlighted in blue to the current location of the laser head.|alt=The "To Pointer" button in UCP.]]
You can see the estimated job completion time by selecting the Estimate View tool and pressing "Start".
Make sure to close the top of the machine. Start the laser job by pressing the green start button on the control panel or in the UCP, and watch the magic happen!Make sure to wait at least 2 minutes once the cut is done to open the top of the machine.
===Turn off the laser cutter and filtration/exhaust===
If a significant amount of material fell through the honey comb structure of the cutting table then it should be cleaned out. The front of the laser cutting can be opened and the table will slide out. There is an opening in the rear of the table that can be used to clean the inside.
== Bending Your Acrylic Cuts (Optional) ==
Additionally, sometimes it may be necessary to alter the shape of your laser cut acrylic pieces for something like a display stand; Examples can be found in our display case located outside of DaBL's entrance. Since acrylic has a relatively low melting temperature, it is possible to heat the plastic so that it softens enough to be molded into a particular shape. For this process, you will need a Linebender and Cooling jig. Both of these apparatus can be found at the laser cutter station. The steps needed to use both are described below.
===Using the Linebender and cooling jigCooling Jig===
If you want to change the angle of a piece or acrylic you will need to use the line bender and cooling jig:
#Once the material has been heated to the correct temperature, lift the material clamp and remove the material. The material is then placed into the cooling jig to cool down to a predetermined angle, while the next sheet of material is placed on the line bender.
[[File:Bender 1.png|alt=The cooling jig|thumb|left|The cooling jig]][[File:Heat.png|alt=The linebender|thumb|The linebender ]]
<br />
==Checklist==
