Changes

You have two was to change the placement of your cut, the first is with the focus view tool which is the tool second from the left, it looks like a drill head, when you select that tool you and press somewhere within the cutting bed you will see the laser head move to the exact place where you clicked on the bed. This tool can be used to eyeball the placement of your cut, once you think you've found the place where you want to place your cut, press the "move to pointer" button on the bottom left side of the screen and your cut will move to where you clicked initially. Another thing to note about moving your cut is that your cut can move based on multiple points on the cut itself, depending on which point is selected will change the exact placement of your cut, it is often advised to use the top left of cut. The other tool to move your cut is the "relocate view" tool, it is the middle most icon. With this tool you can move you cut manually, unlike the focus view tool the laser head will not move as you are moving your cut, this tool can also be used to eyeball where you think your cut should go however it can be used in a much more accurate way. Once you selected the tool should notice that x and y values have showed up under the tool, with these you can perfectly place your cut, another thing to note when placing things using this tool is that the xy values are in mm while the ruler around the cutting bed is in cm so you'll need to convert. Once you've selected the material, inputted the material height, and place the material in the correct spot you can begin your cut.