47
edits
Changes
Jump to navigation
Jump to search
==After Vinyl Cutting==
→After Vinyl Cutting
'''If you need to stop your job for any reason while it is in progress, pull the release lever at the back right of the machine to interrupt the current cut.'''
Once your design is finished cutting, check to make sure all the desired elements are there before releasing the lever. If everything is to your liking do the following:
#Lift the lever, and use Use the white cutter located in the "vinyl tools" drawer.#Start the cut with or scissors, then use the white tool to cut the spool across the ruler edgeout your design.
#Roll the unused spool back up.
#Scrape out the parts you don't want from your design with the red vinyl cutter (dental looking tool) tool. This step is called weeding out the designProcede to Weeding.
#'''If you are making a sticker:'''
##Grab the transfer paper spool and cut out a piece the size of your design.
##Place transfer paper on the design and smooth out any air bubbles.
##Peel the transfer paper off to hold your design together
#'''If you are putting your design on cloth:'''
