Changes

This process is the quite tedious and requires a bit of patience and precision. The weeder should be used to carefully puncture the vinyl and pull material away. The smaller and more intricate the design, the more careful you have to be to not peel up very tiny designs.

After weeding, if using heat-transfer vinyl, follow the Heat Press instructions below. If using adhesive-back vinyl, use the transfer paper to transfer your design to the target surface. Cut out a piece of transfer paper about the size of your design. Peel apart the transfer paper and place the adhesive side on your design. Using the squeegee, smooth out any air bubbles. When ready to transfer the sticker to your target surface, peel the transfer paper and design off and place on surface; smooth with squeegee and remove transfer paper.