310
edits
Changes
Jump to navigation
Jump to search
Being '''''Note: this page is provided as a milling machine, reference for the Bantam creates large volumes of particulates or swarf[[Creative and Technical Specialist|CaTS]] only. ThereforeIf you are not a [[Creative and Technical Specialist|CaTS]], cleaning and maintenance is of a high prioritydo not attempt anything on this page.'''''
add header warning
==Cleaning==
The Bantam Tools Mill creates large volumes of particulates or swarf. Therefore, cleaning and maintenance is of a high priority.
===Daily Cleaning===
# '''Vacuum''' out any swarf from the bottom of machine## Be sure to move the build plate to vacuum underneath# '''Vacuum''' any swarf around the spindle and spindle head# '''Wipe off''' the inside of the windows with a dry wipe# '''Clean''' any swarf that made its way outside of the machine
===Monthly Cleaning===
# '''Turn off''' and '''unplug''' the machine# '''Remove''' all 4 windows# '''Remove''' top metal panel# '''Vacuum''' any and all swarf, be sure to rotate the machine to reach every point# '''Brush''' and '''vacuum''' any hard to reach parts with the small black brush in the tools drawer# '''Use''' compressed air, to remove the last of the swarf, outside if possible## Be extra thorough with the spindle head and motor## Spray into the collet holder, located where the tool bit is inserted# '''Wipe''' the interior with isopropyl alcohol# '''Reassemble''' and '''plug-in'''
==MaintenanceMechanical functionality==
===Daily Weekly Maintenance===
If any part of the maintenance does not seem right or you have questions, contact Kristof.
# '''Check''' if the spindle is wobbly# '''Use''' the software to check if the spindle head and build plate move freely# '''Examine''' build plate for any large cuts or missing sections
===Monthly Maintenance===
# '''Move''' spindle head to the center of the machine and lower it a few inchescm## Not required but will make your life easier later# '''Turn off''' and '''unplug''' the machine# '''Remove''' all 4 windows# '''Remove''' top metal panel# '''Pull''' the two black spindle bands off## Located at the top of the spindle head## Check for any cracks, gouges, or abnormalities and replace them if necessary # '''Wiggle''' the spindle## It should not have any horizontal movements# '''Unscrew''' the black collet holder## Located where the tool bit is inserted## Examine for any abnormalities# '''Check''' the three axes for any nicks or stuck swarf/tape# '''Reassemble''' and '''plug-in'''
