166
edits
Changes
Jump to navigation
Jump to search
→Load the stock into the machine
===Load the stock into the machine===
Open the top of the machine and ensure the ULS Flow-Through Cutting Table is aligned to the straight edge on the base of the bed. This is done by checking the cutting table with the honeycomb support structure is positioned as far left and back as possible when facing the laser cutter. Next, place your material snugly against the top left corner rulersof the cutting table. Your stock should typically be aligned here; it doesn't have to be, but it removes any question of misalignment.
===Send your design to the CAM software===
===Turn off the laser cutter and filtration/exhaust===
In reverse order to how you started, first turn off the laser cutter, then the filtration/exhaust. Congratulations on your lasering!
=== Clean work area ===
If a significant amount of material fell through the honey comb structure of the cutting table then it should be cleaned out. The front of the laser cutting can be opened and the table will slide out. There is an opening in the rear of the table that can be used to clean the inside.
